If the Aeotec Smart Home Hub looks familiar, it's because it's a millimeter-to-millimeter clone of Samsung's third-generation SmartThings Hub. It can integrate a smart home full of devices, as long as they are not based on Apple's HomeKit technology.
Rather than small and unobtrusive, the all-white Aeotec hub is about the size of a 4.9 x 4.9 x 1.1-inch (LxDxH) network router. It is about four times larger than the small Hubitat Elevation node and is huge compared to the Aqara E1. It lacks keyholes at the bottom, so you can't easily hang it on a wall, but its 7-ounce weight means Velcro tape will do the job.
This review is part of TechHive’s coverage of the best smart home systems, where you’ll find reviews of the competition’s offerings, plus a buyer’s guide to the features you should consider when shopping for this type of product.
Showing its technological roots, the Aeotec hub comes with a Samsung AC adapter. There’s also has a power cable, an ethernet cable, and a start-up booklet in the box. Like the Hubitat, it lacks a battery back-up, but because all its commands and settings are stored online, they shouldn’t get wiped out by a power failure.
As is the case with the Hubitat Elevation, the Smart Home Hub has an ethernet port for connecting to a home network. It can’t use power-over-ethernet (PoE) to replace the AC adapter that would have allowed it to be put in places without a nearby outlet. The Aeotec hub goes a step farther than the Hubitat Elevation by including 802.11ac Wi-Fi networking, making it easier to set the Smart Home Hub up in the best place to connect with the entire house rather than just what’s near the router.
Neither the Aeotec nor Hubitat home hubs, however, have a backup communications portal, like a mobile network LTE connection. The Ezla Secure hub has that and a backup battery for fail-over operations as well.
The Aeotec hub’s front status LED lights up green when everything is working, blue when it’s connected to the home network but lacks an internet signal, and alternates between red and green when it’s ready to be configured. The LED is red when it has a hardware issue that requires restarting the device.
Under the skin, the Aeotec Smart Home Hub has a 528MHz ARM Cortex A7 processor that uses 2GB of RAM and 4GB of flash storage for its firmware and local settings compared to the Hubitat’s 1.5GHz quad-core processor, 1GB of RAM and 8GB of storage space. While the Hubitat’s local focus is a benefit when your broadband connection fails, the Aeotec’s internet emphasis means any connected devices can be controlled from anywhere there’s an online connection.
Able to connect with Zigbee (including Philips Hue), Z-Wave, and Wi-Fi devices but not Bluetooth accessories, the Aeotec hub can handle voice commands from Alexa and Google Assistant. It can’t, however, work with Apple’s Siri or HomeKit ecosystem. This could be remedied in the near future thanks to the company’s close relationship with Matter. If all goes well, just about any supported device will theoretically be able to connect with just about any supported hub for the closest thing to universal compatibility that smart home products have ever seen.
In the here and now, the hub works with hundreds of devices, including—unlike the Hubitat—Wemo and Nest devices. Aeotec offers the bonus of a family of smart home products that it sells. The line ranges from water leak and motion sensors to video cameras and control buttons. The company even sells a range extender for Z-Wave mesh networks.
Priced at $135, the Aeotec Smart Home Hub is on a par with the $130 Hubitat Elevation hub. The Aeotec hub comes with a one-year warranty, lifetime support, and doesn’t require any subscriptions. That makes it the obvious choice for cheapskates, like me.
Building a smart home around the Aeotec gear is not like using any other hub. That’s because the Aeotec hardware doesn’t have its own app. Everything is done with the Samsung SmartThings app. There are versions for Android and iOS and the app works with Galaxy SmartTags and other Samsung products. When it’s ready to connect, the hub blinks red and green.
Next, I picked Smart Home Hub from the interface and tapped Start on my Galaxy S20 phone. I noted that the location for the hub is the Office and I allowed the software to see my location.
Next, I selected ethernet rather than Wi-Fi for its connection portal due to higher reliability of a wired connection. It worked just as well using wireless data.
I then scanned the identifying QR code on the bottom of the unit. The app automatically registered the hub and updated its software.
I finished by naming the hub. This took seven minutes to accomplish. It was also among the easiest smart home hub to install.
Time to add devices. After tapping “+” to add my WeMo outlet switch. I picked it from the list and in three minutes it was connected. I followed this up by adding a Leviton DZPA1 Z-Wave Plus outlet and a Linkind Zigbee floodlight.
I had one more task: integrate two of the room’s lights into a group. Rather than asking during the set-up sequence, this needs to be done later. After tapping Add Lighting Group, I named it and added devices. All told, it took about 15 minutes, versus 45 minutes for doing roughly the same thing with the Hubitat Elevation.
[[aeotec lighting group]]
My major work has been done because the SmartThings app is complete with everything you need to control and automate your devices. Unfortunately, the Aeotec hub cannot be accessed through a connected browser, as is the case with Hubitat Elevation, but the Windows 10 SmartThings software worked well.
The good news is that the app is functional in a wide range of uses. For many of the device's screens, there is a built-in switch to turn it off after an hour - a pleasant touch for the forgetful.
For things like Linkind projectors, it seems that the native application has the ability to adjust the color of light and reduce its power. There are also simple automation controls for turning the device on or off at certain times, including sunrise and sunset.
After a few minutes to connect SmartThings with Alexa, voice control worked fine. I was soon able to turn on or off anything, including my group of two lights. There was a big surprise: the application automatically recognized my Samsung M7 smart screen. Without any installation effort, I was able to turn it on and off, change the schedule, and adjust the volume.
The Aeotec hub had a range of 70 feet, using the Leviton smart socket in my 100-year-old home with two intermediate walls. This is slightly smaller than the 75-foot Hubitat's range, but should be fine for most homes, especially if the hub is centrally located or you implement a radius extender.
During the run, the Aeotec hub used 1.6 watts of power. If you pay the national average of 13 cents per kilowatt-hour of electricity, it could cost $ 1.80 per year to use. This seems like a good deal to me, given all the Aeotec hub can do for a smart home.
Easy to learn and use, the best part of the Aeotec Smart Home Hub is its simple but powerful software. Even if the device gets a little long in the tooth, its SmartThings application is the one to be defeated. Everything makes Aeotec Smart Home Hub highly recommended for anyone building a smart home.
HomeKit.Blog is in no way affiliated with or endorsed by Apple Inc. or Apple related subsidiaries.
All images, videos and logos are the copyright of the respective rights holders, and this website does not claim ownership or copyright of the aforementioned.
All information about products mentioned on this site has been collected in good faith. However, the information relating to them, may not be 100% accurate, as we only rely on the information we are able to gather from the companies themselves or the resellers who stock these products, and therefore cannot be held responsible for any inaccuracies arising from the aforementioned sources, or any subsequent changes that are made that we have not been made aware of.
HomeKit.Blog Is A Participant In The Amazon Services LLC Associates Program, An Affiliate Advertising Program Designed To Provide A Means For Sites To Earn Advertising Fees By Advertising And Linking To Amazon Store (Amazon.com, Or Endless.com, MYHABIT.com, SmallParts.com, Or AmazonWireless.com).
The opinions expressed on this website by our contributors do not necessarily represent the views of the website owners.