Skip to content

The Aqara G2H changes from “specific” movements to “any” movements

The Aqara G2H changes from “specific” movements to “any” movements

I’ve had this HKSV camera for a while and for the most part it works great. I set it up to detect specific movements (people, animals and cars) while I’m not home. But for some reason, the notifications just say “motion detected” without specifying what it was. The settings for “specific” movements are intact. This usually happens after a few days of use. The only way to have it detected correctly is to remove the device and add it again. I have an iPad as a homehub, if that helps. The camera firmware is 2.1.1 – updated via the Aqara application.